Re: 1973 Evinrude Mate 2HP Issues
Home › Forum › Ask A Member › 1973 Evinrude Mate 2HP Issues › Re: 1973 Evinrude Mate 2HP Issues
April 24, 2018 at 9:21 pm
#74685
quote FrankR:
That cylinder does not look good in the picture. You might see if a honing will clean it up without making it too oversize.
Do the piston skirts look as bad as the cylinder wall?
Do the piston skirts look as bad as the cylinder wall?
Frank, that was the original block i was trying to make work. I honed it but to no avail. I purchased another parts motor swapped parts around and now its a fire breathing dragon again, although still rather low compression at 90psi.