Home › Forum › Ask A Member › Home made flywheels? › Re: Home made flywheels?
May 20, 2018 at 6:36 pm
#76419
quote Tubs:
The flange doesn’t have a taper.
It is made for a straight shaft.
That is as much of an issue as
the all the bolt holes. With the
factories machining capabilities
it unlikely they would do
anything like this.
It is made for a straight shaft.
That is as much of an issue as
the all the bolt holes. With the
factories machining capabilities
it unlikely they would do
anything like this.
Tubs, it’s hard to see, but there’s actually two different tapers in that
hub. The lower one did fit the crank, and even
though the taper didn’t have as much bearing
as a normal flywheel, it took a lot of effort
with my puller before it "popped" off.
Prepare to be boarded!
