Home › Forum › Ask A Member › OEM support for trailering › Re: OEM support for trailering
June 6, 2018 at 2:59 pm
#77532
That reminds me of the the 35 HP Johnson RD’s in the late 1950’s had that horizontal pin on the transom clamps that pushed in (and wasn’t there a version that screwed in?) to hold the motor up, which if I remember right was for road clearance when trailering – but again – it does nothing for the transom. Maybe more important, It also would hold the motor up during launch or putting it on the trailer – good to have if you don’t know how to tighten the nut to put more tension in the tilt hinge.
Dave