Home › Forum › Ask A Member › Wizard wg7 upper seal › Re: Wizard wg7 upper seal
September 13, 2018 at 2:18 am
#82781
Was able to roll bend the edge down in a few places and get them with a sharp awl and working back and forth worked it out. Put new seal in seems to hold pressure ok without bubbling so putting top end back together. Think i will go ahead and do lower seal and bearings while i have it on the stand. Compression is about dead even at 120. Previous owner said that his dad said he thought the reeds were gone and it would not start. It was the seal reeds seem to be fine.
Doug
how is it motors multiply when the garage lights get
turned off?
