This is a Johnson K45 that I'm working on. I can pull it over a few times and get a spark around an 1/8th of an inch then after that I don't get no spark at all. I rebuilt the coil with two of the OMC coils. At the spark plug wire leads I'm getting a reading of 15 with the meter set at 1k ohms. I'm weak on the electrical stuff. I've used two different new condensers one at 26 the other at 32uf. The magnets seem strong enough compared to a couple of others I've worked on. The coil heels are not rubbing. The only difference I see from a Lockwood I have worked on is that I run the green wires from the coils directly to the points. Could that be my problem? I may have wire arcing somewhere but I'm not seeing it. As always thanks for the help.