Hello to all;
Do the pics show a casting flaw, or a crack, in the bowl of my model E, type 2 carb?
Not great photography or light, I know.
It was more apparent before I took a swipe at it with a shop towel; which makes me think it's more likely a crack than casting flaw.
I can't seem to get it to run right. If the carb is cracked, then that might explain this.
If anyone can tell me how to differentiate a crack from a casting anomaly I'll be grateful. I'll pour some gas in and see if it leaks down, but it hadn't emptied in the week it's been sitting.
All opinions welcome.
Edit; if I polish on it, and it goes away, it was a casting issue. Right? It didn't leak when I filled the bowl w/ gas, but it wasn't bolted down or hot, either. All suggestions definitely welcome. Odds are it's a casting issue, I know, but i'm not gonna bolt it back up 'til I get it figured.
- Carb4.JPG (668.66 KiB) Viewed 503 times
- Crack snip2.PNG (600.3 KiB) Viewed 503 times
- Crack snip.PNG (456.33 KiB) Viewed 503 times
Last edited by Calan
on Sun Jan 21, 2018 8:48 pm, edited 1 time in total.