outbdnut2 wrote:Lloyd Lautner wrote:Are you sure this motor has high enough compression to run at all?
His compression is likely a bit higher due to the volume of air in the tester hose, as the check valve is at the gauge end.
outbdnut2 wrote:I'd spray some starting fluid in the carb and see if it fires on that, and then it may stay running long enough to tweek the carb adjustments. Use starting fluid that contains lubricant - most brands do.
Steve D wrote:In addition to your wire issues you could very well have water intrusion. Your picture makes it seem possible. Bad exhaust cover gasket? Are the stack of parts on the driveshaft in good order, especially #1 the gasket?
Users browsing this forum: No registered users and 5 guests