Caping Transom

Home › Forum › Ask A Member › Caping Transom

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • May 11, 2016 at 6:39 pm #4260
    aziegner
    Participant

      Hi,
      I am from Newfane, VT 802-258-8868. I repaired the transom on my 1960 Corson. Any ideas on how to cap it. There was metal but that rotted away and didn’t work to good.

      May 12, 2016 at 12:22 am #36438
      Steve A W
      Participant

        US Member - 2 Years

        Here’s a link to a thread on a restoration project.
        Scroll down about 1/3 of the way and he tells how he did it.
        I’m going to try this when I get back to working on my boat.
        http://forums.iboats.com/forum/boat-rep … esto/page5

        Steve A W

        Member of the MOB chapter.
        I live in Northwest Indiana

        May 12, 2016 at 1:09 am #36444
        jeff-register
        Participant

          US Member - 2 Years

          If you need to use glass resin be sure to use epoxy resin. The inexpensive laminating resin is not near as strong as epoxy.

          May 12, 2016 at 12:09 pm #36456
          crosbyman
          Participant

            Canada Member - 2 Years

            http://www.amazon.com/Runabout-Renovati … 0071580085

            not a bad book to have !

            Joining AOMCI has priviledges 🙂

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.