Home › Forum › Ask A Member › Evinrude Fisherman water pump question › Re: Evinrude Fisherman water pump question
I took the top cover off the motor and looked at the motor and compared to the videos on YouTube.. preparing to remove the power head.
http://www.youtube.com/watch?v=EY2HrEdp5vg
https://www.youtube.com/watch?v=SVOedhzPP7M
Besides the fuel line it looks like I also need to remove/disconnect:
1) Choke cable, looks like a small pin will disconnect the cable/joint/junction
2) Low Speed Mixture dial – looks like I need to unscrew this out of the carb.. does that sound correct ?
3) Pull cord and/or pull cord spring… will the unit become "unsprung" or anything like that when I take it off ?… it looks like a couple/few 10mm bolts hold it on.
I found the bolts that hold the head on, they all look reachable.
I did not get a gasket set yet… I thought it might be best to find out what I need and then place an order. I did pick up a new water pump impeller last night, but I suspect I’ll need more parts.
Any suggestions on 1-3 above or anything else ?
I plan to work on the motor tomorrow evening.