1957 Evinrude 35 hp powerhead removal

Home › Forum › Ask A Member › 1957 Evinrude 35 hp powerhead removal

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 11, 2016 at 1:56 am #4716
    mgsolakis
    Participant

      Canada Member - 2 Years

      So my Evinrude 35 hp won’t go into gear anymore. I was told in my last post to pull the powerhead to get at the problem. I have a complete parts motor to pull from. So I’m wondering how I pull the head. I clearly see 6 screws that seem to hold it on. Anything else?

      Thanks

      July 11, 2016 at 2:04 am #39998
      frankr
      Participant

        US Member - 1 Year (includes $3 online payment fee)

        Yep, two bolts with 1/2" hex heads near the rubber mounts, and two nuts, also 1/2" hex on the inside, up front. And a screw holding the silencer to the lower front pan. It will also be easier to put back together if you remove the shifter interlock bar from the side, and the vertical throttle shaft on the opposite side. And of course any hoses or wires.

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.