Home › Forum › Ask A Member › TUBE BENDING › Re: TUBE BENDING
December 27, 2017 at 10:26 pm
#69029
Tubs, I used a 3/8” OD thin wall tubing I found on eBay. I looked for the link, but didn’t see that posting anymore. I could dig around through my receipts if you want to buy from the guy.
I’m almost embarrassed to post pictures of my tube bending expertise.
I even cracked the right one, and put some JB Weld on it…. geese what an armature I am.
Thought it would be ok with the low pressure application. Never got the motor to start, and put it on the back burner. Don’t even get me started on those bizarre end fittings that Evinrude used in the 20’s.
Bob D