Home › Forum › Ask A Member › To Hone or not to Hone is the Question › Re: To Hone or not to Hone is the Question
March 16, 2018 at 1:04 am
#72559
quote :
I see there’s a slight taper on
the inside of the rings and I have no idea which
way to re-install
I just got new rings from Otto’s for a 7.5 Evinrude 1957. The instructions say install with bevel up. To be sure I searched "piston ring bevel" and found five manufacturers who all say "up".
Iam assuming that up on a horizontal cylinder is toward the plug. :0