Home › Forum › Ask A Member › 1950’s OMC Nylon Idle Adjust screw › Re: 1950’s OMC Nylon Idle Adjust screw
July 10, 2018 at 6:30 pm
#79338
quote aquasonic:
Those screws are 1/4-20. The nylon is favored because if the motor falls or is impacted, the casting probably won’t break.
There was a thread on here this past spring about these screws. I bought a bag of ten nylon thumbscrews from Grainger for under $3.00. They aren’t exactly the same as factory, but a respectable replacement.
Thank you kindly!!! 🙂
Cajun