Re: Fleetwin Exhaust Plate
Home › Forum › Ask A Member › Fleetwin Exhaust Plate › Re: Fleetwin Exhaust Plate
September 3, 2018 at 6:26 pm
#82235
Agree with Chris on making sure head bolt threads are clean prior to installation to get a proper torque setting. I either wire brush any bolts I intend to re-use or just use new bolts. I also run a thread chaser (not a tap) down all bolt holes to clean them out. Amazing how much crap you can dig out of some head bolt and exhaust cover bolt holes.
Bob
1937 Champion D2C Deluxe Lite Twin
1954 Johnson CD-11
1957 Evinrude Fastwin 18
1958 Johnson QD-19
1958 Johnson FD-12
1959 Johnson QD-20
“Every 20 minute job is only a broken bolt away from a 3-day project.”
"Every time you remove a broken or seized bolt an angel gets his wings."