Topic: can anybody id this tool? – Antique Outboard Motor Club,Inc

This topic has 6 replies, 6 voices, and was last updated 9 years, 8 months ago by dan-in-tn.

Viewing 7 posts - 1 through 7 (of 7 total)

Author

Posts
March 24, 2015 at 3:43 am #1011
opposedtwin
Participant
US Member
it was with a bunch of outboard parts I came across. I imagine it’s a puller of some sort. anybody know for sure?
March 24, 2015 at 3:57 am #12664
mr-asa
Participant
Looks like it would expand something. That screw would interfere with the jaws as it was tightened which would spread them out.
March 24, 2015 at 4:03 am #12666
Anonymous
It could quite possibly be a flywheel and/or carrier puller of some sort. ❓
March 24, 2015 at 4:06 am #12667
garry-in-michigan
Participant
Lifetime Member
I think it goes with a slide hammer. Used for pulling Seals and outer bearing races …
March 24, 2015 at 4:13 am #12669
mr-asa
Participant
I think Garry wins again.
March 24, 2015 at 4:29 am #12670
Mumbles
Participant
It’s part of a set for installing and removing upper gearcase bearings.

http://boatinfo.no/lib/evinrude/manuals … e_h336.swf
March 24, 2015 at 5:12 am #12671
dan-in-tn
Participant
US Member
Per the ’76 special tool catalog the #380657 (which can be seen in the pic) is used with slide hammer #380657 to remove propeller shaft bearing cup on 1974-76 9.9 & 15 hp models. Also removes bearing assy #379503 & needle bearing assy #379505 from 1966-68 100 hp outboard gearcases. Also used on stern drives with same applicable gearcases. That’s straight from the book.
I have used mine for all kinds of other stuff. It will pull almost any seal you can stuff it into. I have another one I have modified so it goes into a smaller hole. Neat all around tool.

Dan in TN
Author

Posts