Tank Rust removal via Electrolysis

Home › Forum › Ask A Member › Tank Rust removal via Electrolysis

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • April 10, 2015 at 1:50 pm #1152
    drifter
    Participant

      I’m going to start rust removal on a pressure tank that is cosmetically very nice. The rust is not bad, but enough that I want to remove it.
      I’m going with electrolysis. I’ve used other methods on other tanks with very good results, but I’m choosing electrolysis this time because I want the learning experience and, from what I read, it works very well.
      I’ve got the procedure down from lots of research.
      My question is, what tips or tricks can you offer? Anything I should watch out for?
      Thanks,
      Nick

      April 10, 2015 at 5:48 pm #13669
      phil
      Participant

        US Member - 2 Years

        See post near bottom of page, titled "Mumbles, electrolysis ?"Should give you the answers you are looking for.

        http://www.omc-boats.org
        http://www.aerocraft-boats.org

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.