Cowling seal/gasket

Home › Forum › Ask A Member › Cowling seal/gasket

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 25, 2024 at 7:32 pm #286246
    CARY PALMER
    Participant

      US Member

      Restoring the cowlings on my 1973 Johnson 4 horse & a 1975 Evinrude 15 horse and am looking for replacement cowling seals.

      March 25, 2024 at 11:37 pm #286253
      crosbyman
      Participant

        Canada Member - 2 Years

        frequent subject… some slice a small fuel line down the middle and  glue on the rim

         

        some by the real thing  from…  http://nymarine.ca/cowlgaskets.htm

        or you can investgate  door trims on Amazon which come in diffrent sizes ..

        Edge Trim Black large U height 0.656″ U Height x 0.039″-0.178″ grip range (10 Feet) : Amazon.ca: Automotive

         

         

         

        Joining AOMCI has priviledges 🙂

        March 28, 2024 at 1:45 am #286322
        Mumbles
        Participant

          I’ve used the ones from nymarine on a few restorations  and while a bit pricy, they are as the originals and of good quality.  They can be a bit of a challenge to install but it can be done in a few hours using the original staples and super glue/clamps to get them to lay flat.

          http://www.nymarine.ca/

          March 30, 2024 at 6:44 pm #286409
          CARY PALMER
          Participant

            US Member

            Thanks for the replies fellas.  I went ahead and reached out to nymarine to make sure I get the correct style.  Sure wish I could find it in white since that is what was on the motor.

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.