Spark Plug Spring Terminals

Home › Forum › Ask A Member › Spark Plug Spring Terminals

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • October 23, 2024 at 2:11 pm #291706
    Mumbles
    Participant

      Anyone ever seen terminals like these?  They came with some ZhongFaTec coils I bought off Amazon.PXL_20241023_180351758

      October 23, 2024 at 2:53 pm #291708
      Mumbles
      Participant

        I figured it out and nipped one of the prongs off. They sure are a lot thinner gauge than the originals. About .034 vs .050.PXL_20241023_184840673

        October 24, 2024 at 5:43 pm #291736
        joecb
        Participant

          US Member

          Thinner gage wire… think maybe the two prongs are to compensate for pull out strength. Why not just go with the two prongs?

          Joe

          October 24, 2024 at 5:53 pm #291737
          crosbyman
          Participant

            Canada Member - 2 Years

            agree with  joecb…. I would sharpen up both  “points”  to ease the installation.

             

            install the boot  on the plug wire / slip it  out to install  the spring   then pull it back in  carefully

            Joining AOMCI has priviledges 🙂

            October 24, 2024 at 9:57 pm #291740
            joecb
            Participant

              US Member

              I have had good success pushing the terminated wire end into the boot, if the boot is stiff, warm it by soaking in hot water.

              Joe B

              October 30, 2024 at 11:37 pm #291840
              Mumbles
              Participant

                Two prongs were probably meant to help keep the terminal from coming off the wire but installing it would have been beyond my capabilities.  The first time I pulled the boot off the plug, the new terminal got left behind still attached to the plug. Using the original terminals seemed the logical choice so that’s what I did.

              • Author
                Posts
              Viewing 6 posts - 1 through 6 (of 6 total)
              • You must be logged in to reply to this topic.