Shift Lever Housing Bushing Source – 1980-2005 2-cyl 20,25,30,35

Home › Forum › Ask A Member › Shift Lever Housing Bushing Source – 1980-2005 2-cyl 20,25,30,35

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 28, 2024 at 12:16 pm #291774
    durco
    Participant

      US Member

      Howdy, Boys:

      There s a brass (or bronze) bushing pressed into the hole where the “adjustment lever & shaft assy.” (in other words the shift handle shaft, upper starboard side) goes through the midsection/exhaust housing) on my 1984 31.8 cubic inch 35.  I want to replace it with a new one because my shift lever is getting “floppy” from wear to this bushing.  I have looked in parts diagrams from 1977 to 2005, and none I see show this bushing.  Does anyone know of a parts source for this piece, or is it something I am going to have to make?  Thanks as always.

      Mike (AOMCI member)

      October 28, 2024 at 9:34 pm #291783
      frankr
      Participant

        US Member

        I would assume the bushing is cast in place and not intended to be replaceable. That would mean make your own.

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.