Topic: 1947Evenrude sportsman cooling system – Antique Outboard Motor Club,Inc

This topic has 4 replies, 2 voices, and was last updated 9 years, 8 months ago by stanley.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
March 19, 2015 at 8:55 pm #966
stanley
Participant
US Member - 2 Years
Running at speed how much water should be coming out of the three horizontal slots above water? Or is the discharge under water at this point?How can I be sure enough is circulating?
March 20, 2015 at 3:41 pm #12403
garry-in-michigan
Participant
Lifetime Member
There should be a fairly steady spray. Most will go out under water with the exhaust. The water jacket on those outboards consists of a turn and a half of copper tubing placed around the grey iron sleave when it is put in the die casting machine. The copper is much more resistant the corrosion but harder to clean if it gets plugged up. It’s hard to find a reliable Roto-Rooter that small.

. . . 😉
March 20, 2015 at 4:19 pm #12405
stanley
Participant
US Member - 2 Years
Thanks.It also appears from the drawing that there may be some parts missing in pump.Mine only has one set of impellars,3 armed and flexible rubber.I am looking for my tiny sewer snake.
March 21, 2015 at 2:40 am #12432
garry-in-michigan
Participant
Lifetime Member
The rubber pump doesn’t work in that model – Without the other parts.

These are the parts used in 1948 . . . 🙁
March 21, 2015 at 9:05 pm #12480
stanley
Participant
US Member - 2 Years
That explains it.I swapped a bottom section from a parts motor and had good water discharge,but that pump had different impellars.It was like the one in the 46 drawing you posted.I am new member and this is my first project along with another motor.All the help I’ve gotten here is awsome!!
Author

Posts