1958 Evinrude 10 hp Sportwin New Pinion Gear

Home › Forum › Ask A Member › 1958 Evinrude 10 hp Sportwin New Pinion Gear

Viewing 5 posts - 21 through 25 (of 25 total)
1 2 3
  • Author
    Posts
  • March 14, 2021 at 4:02 pm #233843
    Mumbles
    Participant

      It should be OK then. It is a combination bushing and thrust washer and it takes all the forward thrust developed by the prop.

      When you reassemble the gearcase, tap the prop shaft forward to seat the thrust bearing before tightening the screws down completely.

      • This reply was modified 3 years, 9 months ago by Mumbles.
      • This reply was modified 3 years, 9 months ago by Mumbles.
      March 15, 2021 at 8:07 am #233896
      fleetwin
      Participant

        US Member - 2 Years

        Glad you caught it before you got it all assembled…Surely didn’t want your rebuild to go south on you…Look for a new forward gear on ebay, I will have a look also….

        March 15, 2021 at 11:41 am #233917
        Mike Nazarenko
        Participant

          All set with the gear, its on the way. Thank you.

          March 16, 2021 at 8:54 pm #234031
          Anonymous

            The upper ? forward gear has rounded edges on the teeth, it is not good enough condition to reuse. It should be replaced or you will be right back doing the job again.

            March 16, 2021 at 9:20 pm #234034
            Mike Nazarenko
            Participant

              My rebuild has been delayed until Saturday or so when the new forward gear arrives.

              Thank you for your comment.

            • Author
              Posts
            Viewing 5 posts - 21 through 25 (of 25 total)
            1 2 3
            • You must be logged in to reply to this topic.