Clarke Troller Wiring Questions

Home › Forum › Ask A Member › Clarke Troller Wiring Questions

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 9, 2016 at 4:30 am #3604
    kevinrude
    Participant

      There are 2 single wires (labelled A and B) and 1 wire pair (labelled C1 and C2). See diagram and pictures below.

      I have A figured out; that’s just regular spark plug wire.

      Is there any requirements on what type of wire I should be using for B (coil to condenser)?

      Same question for C1 and C2 (battery to coil), any particular size, kind?

      Also, do I have the battery hooked up properly in the diagram? Positive to coil, negative to ground?

      Thanks!

      February 9, 2016 at 3:08 pm #31691
      Tubs
      Participant

        Your diagram is missing the points.

        A "Boat House Repair" is one that done without having tools or the skills to do it properly.

        February 9, 2016 at 7:59 pm #31697
        kevinrude
        Participant
          quote Tubs:

          Your diagram is missing the points.

          Hmmmmmmmmmmm.

          OK, I will take a closer look tonight and redo my sketch.

          Thanks.

          February 10, 2016 at 2:58 am #31722
          kevinrude
          Participant

            Here is a picture of T2’s Clarke Troller (I must have downloaded the pictures when he posted them at some point). You can see the wire attached to the condenser, which is then connected to the points. So, my diagram could have been better. Hopefully this picture helps.

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.