Old and unusual screw sizes

[amuller]

Thank you! I’ve never had a numbered machine screw chart that went as high as 30. My copy of Machinery’s Handbook (1976) does not go above #12.

[T….in Wisconsin]

pm-t2,

Could I buy from you a set of these 10-30 screws that work with a puller?

I’ve never liked a hammer to the nut either.

 

[joecb]

Tim, are you sure about the size… #10- 30 ? that seems very strange and kinda’ small for pulling.   In any case that would be a lathe job, not too difficult.

Joe B

PS, no problem with the hammer method if you use a thread protecter ( knocker) and lift up on the flywheel .

[Author]

Posts